S&S Cycle T124 Manual de Serviço Página 1

Instruction 51-116010-26-06Copyright®, 2003, 2006by S&S Cycle, Inc.All rights reserved. Printed in the U.S.A.Because every industry has a leaderI

5- Remove the transmission top cover. Remove theneutral indicator switch, vent line and fitting fromthe transmission top cover.6- Install the neutral

12- Press the oil line retention plates into place untilthey seat. Install the two screws (5⁄16-18 x 3⁄4 buttonhead) through the oil line retention pl

12C- Oil recommendationsNOTES● S&S®Cycle recommends the use of Mobil 1®V-TWIN 20W-50 synthetic oil in our engines.● S&S Cycle recommends the u

9- Initial Start-Up And Engine Break-In NOTE - engines are designed for high performance and assuch are not as tolerant of inadequate break-in as stoc

10- Tuning GuidelinesIgnition timing and carburetor jetting are responsibilitiesof the customer. If not thoroughly familiar with theseprocedures, cont

15Torque Values Specification S&SSuggestionRocker box hardware 1⁄4” 120 in-lbs. Loctite®243Rocker box hardware 5⁄16”18 ft-lbs. Loctite 243Tappet

161. Bolt, stator 10-24 x1” SHC - 4 required(H-D#2720)(10 Pack) ...50-01942.Seal, sprocket shaft (H-

2SAFE INSTALLATION AND OPERATION RULES:Before installing your new S&S part it is your responsibility to read andfollow the installation and mainte

1- IntroductionS&S®T124 Engines are available in two versions The firstversion is designed and intended for installation in a stockHarley-Davidson

2- Additional Features:● Greater overall strength than stock crankcases, especiallyin the front motor mount, an important consideration inhigh perform

53- Modification NotesS&S®Cycle cautions against modifying these crankcasesdue to the possibility of damaging or weakening them.Modifying S&S

67- If gap exists, fabricate shim just thick enough tofill gap8- Install opposite corner shim and mounting boltand nut, and tighten identical to other

7- Oil Line InstallationA- For 1999-2006 Harley-Davidson®FL models Oil line installation is crucial to engine life. If you are not surethat you can p

7- Mount the oil line block on the crankcase using 5⁄16-18 x 13⁄4” long screw (S&S®PN 50-0437)—do not finaltighten as it will be removed again.8-

91-Block, Oil line ...............106-11682-BHSHCS, 5⁄16-18 x 13⁄4 (10 pack) .........